Runco RS-440LT Specifikace Strana 61

  • Stažení
  • Přidat do mých příruček
  • Tisk
  • Strana
    / 84
  • Tabulka s obsahem
  • ŘEŠENÍ PROBLÉMŮ
  • KNIHY
  • Hodnocené. / 5. Na základě hodnocení zákazníků
Zobrazit stránku 60
Operation
Runco RS-440 Installation/Operation Manual 47
PRE
L
IMINAR
Y
InstallationTo access the Installation adjustments, press MENU, then press the or button to
highlight Installation and press ENTER. The Installation sub-menu appears. Press EXIT to
return to the previous menu or press MENU to close all menus.
Language: Select Language from the Installation menu and press ENTER. Then, use the
or button to select from the available languages: English, French, Spanish, German
and Italian.
Orientation: Select Orientation from the Installation menu and press ENTER. Then, use
the or button to change the orientation of the projected image. The RS-440 can be
installed on a ceiling or in a rear-screen configuration with one or more mirrors. There are
four settings: Floor Front, Ceiling Front, Floor Rear and Ceiling Rear.
Keystone: Projector placement and other factors can cause geometric distortion in the
projected image. To correct this, select
Keystone from the Installation menu. This
sub-menu provides the following options:
V. Keystone/H. Keystone: To correct distortion resulting from the angle of projection,
select
V. Keystone or H. Keystone from the Keystone menu and use the or button
to make the image rectangular. See Figure 4-6.
Installation
Language
Orientation
Keystone
Overscan
YUV/RGB Adjust
OSD Timeout
Vertical Correction
When you change a setting in the Installation menu, the change takes
effect immediately; you do not need to press ENTER afterwards.
(Press EXIT to return to the previous menu or MENU to exit.)
Note
V. Keystone 0
H. Keystone 0
Runco recommends that the keystone feature not be used unless
absolutely necessary, as it may cause artifacts in the image.
1. The RS-440 keystone correction can compensate for up to
approximately 15 degrees of screen and/or projector tilt.
2. Straight lines or the edges of images may appear jagged while
adjusting the image.
Tip
Note
Zobrazit stránku 60
1 2 ... 56 57 58 59 60 61 62 63 64 65 66 ... 83 84

Komentáře k této Příručce

Žádné komentáře