
Installation
Signature Cinema™ SC-50d/SC-60d Installation/Operation Manual 41
PRE
L
IMINAR
Y
3.8
Turning on the Power
1. Power up your source components.
2. Turn on the main power switch at the rear of the projector.
3. If this is an AutoScope-equipped projector, turn on the main power switch at the rear
of the AutoScope lens motor. The lens motor power switch is located next to the AC
input (see Figure 3-18).
4. Turn on the main power switch at the rear of the DHD Controller.
5. Press the ON button on the remote control (or the ON/STANDBY ( ) button on the
DHD Controller front panel) to turn on the system. The vacuum fluorescent display on
the DHD Controller front panel briefly displays “Initializing System,” followed by
“Starting SC-50d/SC-60d.”
6. When the display is ready for use, the fluorescent display indicates the active source,
input resolution/frame rate and aspect ratio; for example:
HDMI 1
16:9 1080i/60
Current
Source
Aspect Ratio
Input Resolution/Frame Rate
SC-50d/SC-60d
1080p/60
Komentáře k této Příručce